Introduction
We don’t build UV lamps for showrooms. These are workhorses, made for the grit of industrial lines. Our whole focus is on nailing one thing: precise wavelength control. It all comes down to the physics inside that quartz arc tube. Get the heat profile right, and your line just… runs. Without drift. Without the guesswork.
The Inside Story
Here’s the thing: the specs aren’t just numbers on a page. They’re the reason this thing works where it matters. We built it to run on a 400V input, the standard for most industrial power grids. That means you can plug it in and go. No extra transformer needed. The 2500W power packed into a 300mm tube? That’s intentional. It’s a high heat density, concentrating a lot of energy into a small footprint. But it also means your equipment needs to be ready for that kind of thermal load. And that 300mm length? It’s a common size, chosen specifically so it drops right into existing reflector housings. A straight-up retrofit.
What It’s Made Of
We use high-purity quartz for the tube. It handles the shock of rapid heating and cooling, and it lets the exact wavelengths we want pass through cleanly. Inside, a halogen cycle keeps the filament stable. No premature burnouts. The coating is engineered to be picky—it filters out the wavelengths you don’t want, so you get a repeatable heat curve every single time. Then there’s the R7s connector. It’s practical, not fancy. A secure, bi-pin lock that handles high current. On the shop floor, it means a quick, simple swap.
On The Line
Think about PET blowing. You need to heat the preform surface to just the right temperature. Too much energy and you’re wasting material. Too little and you get defects. Our lamp hits that sweet spot with precision. The output is consistent across the whole length of the tube, which means your parts are stable and the reject pile shrinks. The R7s connector also cuts down on wiring mistakes and makes changeovers faster. But let’s be honest—the trade-off is real. That 2500W density demands serious cooling and proper thermal shielding. We build the lamp to take the heat, but your machine has to be ready for it, too.
The Obsession
In our R&D lab, we don’t chase brightness for its own sake. It’s all about tuning the wavelength. That’s what controls how the material absorbs the energy. That precision is the real barrier. It’s what keeps your process stable, shift after shift, when you’re running 24/7.
The Quick Look
- **Power:**2500W
- **Voltage:**400V
- **Length:**300mm
- **Connector:**R7s
- **Tech:**Halogen, Quartz, Selective Coating